Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » Gasguy3713

View Profile: Gasguy3713
Gasguy3713 is on a distinguished road
Gasguy3713 Gasguy3713 is offline
Junior Member
 
Last Activity: 12-14-2013 06:48 PM 

Burner cutting in and out during startup of gas heater
Try cleaning it as well. It is very simple. Just pull it out and rub it with some steel wool. These sensors produce micro amps and have very tight tolerances and while repositioning it may have...
Ignitor Wire Connector
Just pull hard. It will come off. You may be able to slide the rubber part back then grab it with a set of needle nose and pull it off.make sure the power is off to the unit first.
Carrier Heater doesn't turn on please advise
Sounds like you got it figured out....bad circuit board. You have to purchase the whole board.
Carrier Heater doesn't turn on please advise
Sounds like you got it figured out....bad circuit board. You have to purchase the whole board.
Forum Info Contact Info
Join Date: 12-04-2013
Posts
Total Posts: 4 (0.01 posts per day)
Last Post:
Carrier Heater doesn't turn on please advise
12-04-2013 09:38 PM
Find all posts by Gasguy3713
Find all threads started by Gasguy3713
Referrals: 0
Gasguy3713 has no contact information.
Additional Information Group Memberships
N/A
Gasguy3713 is not a member of any public groups


All times are GMT -7. The time now is 11:38 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17