| Register | FAQ's | New Posts | Today's Posts | Extras |
| » frankm17 |
| View Profile: frankm17 | |||||
|
|||||
|
Well after a few weeks away I came back to this and got it sorted out. I finally found the wiring sheet inside the oven and compared it to the service guide available online (which was published 8... |
|
I have not been able to get to the transformer - did not need to remove the control panel to get at the door open switch, it was just covered by a panel with ventilation holes. The light socket... |
|
I made a voltage probe to check this out and it seems that the socket is getting 120VAC when the light circuit is on (door open or oven light switch engaged). I thought this was supposed to be a... |
|
Thanks to Dan O's advice, I was able to repair the door-open switch on this oven, but in the process I dropped/broke the bulb. I got a Maytag replacement bulb (although this just appears to be a 12v... |
|
Thanks to your help I fixed this problem! Once I was able to get the cover off I saw that the switch which the rod engaged had lost one of the two mounting screws and the other screw was loose, so... |
|
OK I see now - the rod goes right into the switch which is then wired to the control panel. So, it should just be a matter of replacing the switch? I think this would be part 16 (Switch - door lock... |
|
Thanks for the info. I did find the rod that the door pushes in on when closed, made sure it was still pushed in, but that didn't do anything. Are you saying I should trace the wires from that rod... |
| Forum Info | Contact Info | |
|
Join Date: 06-15-2009
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|