Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » FallenAngel

View Profile: FallenAngel
FallenAngel is on a distinguished road
FallenAngel FallenAngel is offline
Junior Member
 
Last Activity: 08-11-2013 12:58 PM 

Washer works then doesn't
Well I tore in to it today finally, took the back off and looked for loose connections. Sure enough there was a ground wire on the motor that was very loose, crimped it a little put it back on, works...
Washer works then doesn't
Thanks for the reply Simon, I'm going to tear into it this Sunday and check all the connectors and wires.
Washer works then doesn't
I already had that panel off, I touched and wiggled all the wires and pushed on the connectors to the motor and the control board I couldn't find anything loose but after I plugged it back in it...
Washer works then doesn't
I also am getting F 28 when I do the diagnostic test
Washer works then doesn't - Washer works then doesn't
After starting wash cycle, panel lights up and you can hear relays clicking then nothing. Tried turning to Drain/Spin sometimes it will drain and spin other times it wont. Already replaced drain...
Forum Info Contact Info
Join Date: 11-28-2012
Posts
Total Posts: 5 (0.01 posts per day)
Last Post:
Washer works then doesn't
11-28-2012 02:30 PM
Find all posts by FallenAngel
Find all threads started by FallenAngel
Referrals: 0
FallenAngel has no contact information.
Additional Information Group Memberships
N/A
FallenAngel is not a member of any public groups


All times are GMT -7. The time now is 07:02 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17