 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » fairbank56 |
| View Profile: fairbank56 | |||||
|
|||||
not spinningI don't know about the lint problem but for the record, a broken tab on the brake cam driver cannot cause the clutch hub to stop spinning. You said it wasn't spinning during spin mode. The only thing... |
|
Newer style GE washer "3phase" motor Check voltages with rightmost connector disconnected. If you are getting 38 volts where you should be getting 120 volts, then you have a timer problem. It appears also that the motor/inverter is... |
|
washer control panel all lights flashing -wont start Did you transfer the model select connector from the old control board to the new one? It's the connector with a single jumper wire on it. Eric |
|
GE washer not agitating If you can easily rotate the lower agitator by hand, the splines are probably stripped inside the agitator coupler... |
|
Kenmore 800 Series Washer Issues I would first check the voltages at the water inlet valve solenoids. When set for cold water and filling, you should have 120vac across the cold water solenoid connector. The ATC will cycle these... |
|
Kenmore Washer Won't Cycle -Fails Tachometer Test First check for a loose nut on the main drive pulley. Very common problem which causes the basket drive to not engage properly for spin. If that's not the problem, I would just replace the shift... |
| Forum Info | Contact Info | |
|
Join Date: 10-16-2012
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
