 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Ex-SearsTech |
| View Profile: Ex-SearsTech | |||||
|
|||||
Problem with Kenmore DishwasherI thought there was a sticky but i dont see it. You need to remove the lower spray arm and the cover below it, and yet another smaller cover below that. You will need some torx tips to get the screws... |
|
Problem with Kenmore Dishwasher You almost for certain have something down in the impeller. I think there is a sticky here on how to clean it out. |
|
Dishwasher not filling Are you sure the water is on ? Is the water valve getting power when it's supposed to be ? |
|
Is my replacement Water Valve bad too? Put your meter leads on the wire harness side, start the dishwasher. You should get 120 volts to that valve just a couple minutes into the cycle, less than 10 minutes for sure. |
|
Frigidaire FDB126RBQ2 - Tower Arm/Circulation Motor Failure I have seen a few of these motors burn up because the thermostats are bad and so the wash cycles goes on and on . Especially when people turn it on before bed or just aren't paying attention to the... |
|
Frigidaire dishwasher won't cycle Try a cold water wash and see if it cycles properly. If it only stalls on hot wash then it is most likely the thermostats unless the element is bad. If it stalls on both its probably the timer. |
|
Brand new Microwave Turntable not turning It is either physically binding and unable to turn, the motor is bad, or the motor is not getting power from the main board. You need to see if it is getting the power to it and if it is , the motor... |
| Forum Info | Contact Info | |
|
Join Date: 04-28-2009
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
