 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » donald.may |
| View Profile: donald.may | |||||
|
|||||
Dryer too hot in back and topthanks for the reply. the back gets hot enough that you cannot keep your hand on it for more than a second. It is hot on the heat shield but more so on the left side looking from the back. This is... |
|
Dryer too hot in back and top Just how hot should the back of the dryer get? I replaced both stats, checked the heating coil, cleaned everything and the back is still getting real hot. |
|
Dryer too hot in back and top Thanks for all the help. I am replacing both due the age of the dryer. Let you know how it goes. |
|
Dryer too hot in back and top when i test the control stat, I have 0.000 on the end to end terminals and 1.0 on the top to bottom which according to the diagram is the heater contact you discribed. When I hear it click, I test... |
|
Dryer too hot in back and top Sorry about that. The heating elememt itself is not touching the case (which is screwed to the cabinet) When I disconnect the terminal, I get a reading of 11.7 ohms. If the element is good and... |
|
Dryer too hot in back and top When checking the heating element, none are touching the case. The ohm reads 11.7 when disconnected so it seems the element is ok |
|
Dryer too hot in back and top I have digital which reads 1 when not touching. I got another high limit switch and they both open and read the same until they close so I assume they are good??? The heating element case does... |
| Forum Info | Contact Info | |
|
Join Date: 09-15-2009
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
