 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » c893 |
| View Profile: c893 | |||||
|
|||||
jenn air main board programming - jenn air main board programmingInstalled a new main (high voltage) board. The LED readout is now a non-flashing "PE0" but I can't get it to change. The "press door alarm, then freezer down" etc., sequence doesn't do anything. Any... |
|
Compressor starts when cool, not when haot - jenn air main board programming It has a dedicated circuit. It behaves the same on an alternate circuit. |
|
Compressor starts when cool, not when haot - jenn air main board programming My meter reads 123v with the compressor off, but it drops to 118-19 when it tries to start. |
|
Compressor starts when cool, not when haot - jenn air main board programming I only have a very cheap and likely inaccurate amp meter. But when the compressor successfully started it seemed to draw about 9.5 amps, and when it failed to start (i.e., while the relay was... |
|
Compressor starts when cool, not when haot - jenn air main board programming Follow up: When the compressor failed to restart again after cooling the freezer/fridge to proper temps, I went through the above routine again with no effect: hot compressor did not start. I'm... |
|
Compressor starts when cool, not when haot - jenn air main board programming Replaced both thermistors. Unit cooled to proper temps, shut off, then 10 minutes later the compressor began its regular routine of trying to start (relay buzzing) stopping for a couple of minutes,... |
| Forum Info | Contact Info | |
|
Join Date: 10-04-2012
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
