 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » bsaucer |
| View Profile: bsaucer | |||||
|
|||||
8529935 part numberActually, ther are a few 3-speed motors without the 2-wire connector. The white-orange and white-violet wires are connected to the main connector instead. The common must be connected directly to the... |
|
quit spinning noise "Dry Agitate" is not labeled in letters. In most washers it's a tiny mark located at the last 2 minutes of the regular wash cycle (may be trial and error to "hit" it just right). In older washers it... |
|
washer won't finish rinse cycle When you say "trickles out", does it trickle out the drain, or into the washer? You might have a clogged cold water inlet or bad valve. |
|
washer runs the right way till rinse cycle You might not be getting cold water. Either supply is turned off, or water inlet is clogged, or valve or temp switch may be bad. |
|
Kitchen aid not spinning The motor turns one way for agitate. Then it turns the other way for drain. After the water has drained for 2-3 minutes, the motor should stop and start again for spin. If it doesn't spin when you... |
|
Roper Washer will not agitate could be direct coupler. Remove coupler and make sure little hole is not rounded out. |
| Forum Info | Contact Info | |
|
Join Date: 09-10-2011
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
