 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » boulosb |
| View Profile: boulosb | |||||
|
|||||
Maytag Gas Solenoid replacementWould I need to check for a gas leak after the solenoids have been replaced? Where do I check for the leak and how? Is it a matter of smelling for gas? |
|
Maytag Gas Solenoid replacement I have another question. On the right shaft, that is attached to the gas valve assembly, I may have pulled on it a bit, thinking I could get if off. It seems to be attached to the assembly with a... |
|
Maytag Gas Solenoid replacement - Maytag Gas Dryer Solenoid My problem with the dryer was that it would go on normally and then after five minutes the flame would go off. In about 1 or 2 minutes after that, the igniter would glow red or orange, but the... |
|
Maytag Gas Solenoid replacement - Maytag Gas Solenoid replacement I want to try to replace the Maytag DG309 Gas Dryer Gas Solenoids. I tried to take them apart to see if I could do the job. I took the bracket off the left side solenoids. There are 2 solenoids on... |
|
frost buildup on freezer wall - frost buildup reply to Gene Thanks Gene. I had the back cover off yesterday, letting it melt. With a little bit of frost remaining, I put it into manual defrost and watched the rest melt as the heater went on. There did not... |
|
frost buildup on freezer wall - frost buildup reply to Gene Thanks again Gene. I'm thinking it may not be the defrost timer. It seems to be advancing by itself. I put a mark on it. After completely melting the freezer and then letting frost build up for... |
|
frost on freezer wall - frost buildup reply to Gene Thanks. I noticed that after the frost builds up to a certain level, the defrost heater is not able to melt it completely. If I completely turn it off and let the frost melt for a couple of hours,... |
| Forum Info | Contact Info | |
|
Join Date: 10-30-2009
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
