Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » Bothcoasts Handyman

View Profile: Bothcoasts Handyman
Bothcoasts Handyman is on a distinguished road
Bothcoasts Handyman Bothcoasts Handyman is offline
Junior Member
Last Activity: 07-27-2009 10:49 AM 

Kenmore Elite He3 runs but no heat

If you lift the cover/top of the dryer up. (it will pop up held in my snap type holders) there should be a wiring diagram in there.

You can start from the element and trace the wires back...
Garbage disposal
Glad I could help.
dryer noise
Put the belt back on the drum and motor. Spin the drum by hand again. Check and see if the noise returns if it does. It is either the belt, motor pulley or the drum.
Icemaker problem
I never advise a home owner to pull out a ice maker. This has caused most of my 3,465 homeowners over the last 35 years to have more problems than it's worth. If it's frozen ten minutes with the hair...
GE Refrigerator - how do I get the old fresh door gasket off & new on? part# WR24x446
I would leave the door on as you can do more damage than good when removing the screws with the old gasket. Clean the area very well. Place the new gasket in a oven warmed to 200 degrees. Then turn...
AC prbolem!!! help please
I would start at the overload switch. You will need to know the voltage at this switch. It could be the switch is bad, a short somewhere that causes it to trip etc.
GE Refrigerator - how do I get the old fresh door gasket off & new on? part# WR24x446
There should be a strip over the screws that hold the magnetic seal in place. Usually you pry the strip up carefully to reveal the screws.

Good luck
Forum Info Contact Info
Join Date: 07-27-2009
Total Posts: 11 (0.00 posts per day)
Last Post:
GE Refrigerator - how do I get the old fresh door gasket off & new on? part# WR24x446
07-27-2009 01:59 AM
Find all posts by Bothcoasts Handyman
Find all threads started by Bothcoasts Handyman
Referrals: 0
Bothcoasts Handyman has no contact information.
Additional Information Group Memberships
No Problems, Solutions
Fix It Homes, Gardening
Bothcoasts Handyman is not a member of any public groups

All times are GMT -7. The time now is 12:33 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17