Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » bivind

View Profile: bivind
bivind is on a distinguished road
bivind bivind is offline
Junior Member
 
Last Activity: 09-28-2017 07:44 PM 

Maytag Neptune MAH9700 ND error, new pump - Maytag Neptune MAH9700 ND error, new pump
Repairing a Maytag Neptune washer that won't drain - ND error.

Replaced the pump motor and receiving the same error. Ensured that there are not any blockages in hoses/boot.

What is the next test...
Thermador rangetop blue indicator light stays on - Solution
Finally had some time to tackle this job. Was not easy to get to the switches. Since the insides are all fixed as one piece, I had to pull the unit so I could get access to all sides, then remove...
Elecrolux Icon oven heating to only 150 degrees - Elecrolux Icon oven heating to only 150 degrees
I have a three year old Electrolux Icon double oven (electric) where the lower oven will not heat to over 150 degrees, regardless of temperature setting. The upper oven works fine. This only...
Thermador rangetop blue indicator light stays on - PCG304E/01 Rangetop - instructions for accessing potentiometers?
I have two AP3782975 switches in hand for the x-low burners on a Thermador PCG304E/01 rangetop. I removed the star burners and stainless steel top but can't determine how to get to the switches...
Thermador rangetop blue indicator light stays on - PCG304E/01 Rangetop - instructions for accessing potentiometers?
Thanks. I see that I can order them here. Best to order one and replace the one that's bad or just replace both while I'm in there? The right side never had an issue.
Thermador rangetop blue indicator light stays on - Thermador rangetop blue indicator light stays on
The blue indicator light on the left (x-low burner) side of the Thermador PCG304E/01 cooktop stays lit when the burners are turned off. Right side indicator works fine. All burners light as...
Frigidaire gallery ftf2140fs error E41, which control panel to replace? - The correction!!! (always check your sources...)
After not being able to correct the washer with the replacement door lock switch and control board, I decided to give up and replace the washer. Packed up the purchased parts for a return, put the...
Forum Info Contact Info
Join Date: 10-23-2010
Posts
Total Posts: 10 (0.00 posts per day)
Last Post:
Frigidaire gallery ftf2140fs error E41, which control panel to replace?
11-29-2010 12:56 PM
Find all posts by bivind
Find all threads started by bivind
Referrals: 0
bivind has no contact information.
Additional Information Group Memberships
N/A
bivind is not a member of any public groups


All times are GMT -7. The time now is 04:06 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17