| Register | FAQ's | New Posts | Today's Posts | Extras |
| » bbohemian |
| View Profile: bbohemian | |||||
|
|||||
|
Well, the job is done and the washer (knock on wood) has been running fine for a few weeks by now :D :D :D It was not that bad after all with all your help. I could not have done it without having... |
|
The rear shaft spider arms were broken. Btw, this was mentioned in a different post so you may have wanted to respond there... Anyway, the spider arms of the the shaft are attached to the steel inner... |
|
Thanks Gene for your response. I already thought about it since I saw few other posts about the same situation. I wonder however, why Frigidaire doesn't sell the arm by itself - I was able (and quite... |
|
Well, I was impatient so I used a deep penetrating auto lube for the shaft, separated took out the front tub and rigged a log "chimney" to lift the tub from the ground. It took only few taps and the... |
|
I got the tub assembly out, now I am at a stall point. Could someone please verify and help me with 2 things: 1/ The pulley - how do you get it off from the shaft? Do you just pound it off? The... |
|
Thanks Gene & Richard. Few people told me the bearing cannot be replaced on its own so I actually got the shell. However, since I didn't have to pay for it (I was lucky and talked Frigidaire into... |
|
Thanks Gene that helps a lot. Any tips on this project and do you know how long would such a repair take? |
| Forum Info | Contact Info | |
|
Join Date: 06-10-2008
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|