 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Baudretsch |
| View Profile: Baudretsch | |||||
|
|||||
GE icemaker repairSediment and a dirty filter would reduce the amount of water flowing into the tray, which would make the ice cubes smaller. An increase in water pressure would make more water flow, increasing the... |
|
Heating Element Problem First, assuming you've already turned off power to the range, unplug the burner. Now you can use the range while you wait for the part. Then, replace the infinite switch and plug the burner back... |
|
GE icemaker repair If a little water flows into the freezer, then stops, the problem is with the timer, not the fill valve. To access the timer, remove the cover on the front of the ice maker. Then, unscrew the inner... |
|
Dryer Drum Support Rollers Well, you do need to remove the belt and drum, but the rollers are easy. Be sure to replace both of them, even though only the left one appears worn. Also, add a drop of oil to each one. Good Luck |
|
How to test defrost system According to Whirlpool, Unplug the refrigerator unit for about 30 seconds, and turn the thermostat located inside the refrigerator down to warm or off. <li class="step ">... |
|
mr. harry grupp In the bottom of the freezer compartment, at the rear, is a drain hole which leads to a tube. This is probably clogged. Usually, all it needs is to be warmed with a blow dryer (set on low, you... |
|
washer woes I believe that this model has a direct-drive coupler, not a belt. If you hear a sound like the motor turning when it should be agitating or spinning, it's probably the coupler. If there is no hum,... |
| Forum Info | Contact Info | |
|
Join Date: 11-29-2007
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
