 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Aurelia2197 |
| View Profile: Aurelia2197 | |||||
|
|||||
Some water remains after cycle is complete - Flapper check valveSo you access this from the rear. Is that for the kenmore Elite He3? I'm just asking because this thread was originally started for a Maytag and I have the kenmore. |
|
Some water remains after cycle is complete - Flapper check valve How do you get a look at this part? I was able to feel around the outside and didn't notice anything unusual. But I didn't see a way to detach it to get a look. |
|
Whirlpool washer smells moldy whenever idle - Purchasing 2 clamps My clamps were fine, so I did not have to order new ones with the seal. |
|
Whirlpool washer smells moldy whenever idle - Purchasing 2 clamps Jane W Ellis: The answer to your question is no. There is nothing you can do save replacing the door gasket to remove the mold. I've had the same problem. The gasket is called a bellow and it's... |
|
Some water remains after cycle is complete - Mine too I have a Kenmore Elite He3 with the same problem. My husband is considering trying drano since the drain port we can access is clean. Any suggestions as to whether I should let him? |
| Forum Info | Contact Info | |
|
Join Date: 06-24-2009
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
