| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Applianceaid |
| View Profile: Applianceaid | |||||
|
|||||
| Signature |
| Factory Trained & CFC Appliance Repair Technician |
|
The black seal you pulled out should not have been removed. Now the dishwasher is in flood mode. There is a float switch in the bottom of the unit in case water gets down inside in the event water... |
|
Interesting, sounds like the meter was not on the correct setting possibly. Can you confirm a continuity check by touching the meter leads together? Appliance & Refrigerator Repair... |
|
Hello, From what you are saying I would first suspect a venting issue. If you have checked and verified that the dryer vent hose and the line in the wall is clear then I would suspect a thermostat... |
|
Hello, The most common issue on these units is the water line in the door will freeze. Remove the lower kick plate and disconnect the water line. Press the water dispenser and check to see if water... |
|
Hello, This is a very common issue on these units. Order and replace the drain motor to fix. You can verify this by making a live voltage check on the two wires that connect to the pump. When the... |
|
Hello, Below is a link to a video that explains how to test all the components that would cause a no start and heat situation with your dryer. You would need a basic volt ohm meter to make these... |
|
Hello, It sounds like the thermal fuse on the control board has failed. This is the most common issue on your dishwasher. You would need to ohm the fuse out. The fuse should have continuity. Check... |
| Forum Info | Contact Info | ||||
|
Join Date: 02-26-2011
Referrals: 0
|
|
||||
| Additional Information | Group Memberships | ||||
|
|