Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » agdodge4x4

View Profile: agdodge4x4
agdodge4x4 is on a distinguished road
agdodge4x4 agdodge4x4 is offline
Member
 
Last Activity: 09-24-2017 07:02 PM 

Dead dishwasher after NEW parts!!!!! - Dead dishwasher after NEW parts!!!!!
I just replaced the heating element with the kit. New board. NEw element. New everything. It ran for a week. It ran it's last load and now NO LIGHTS come on. No response from the display. ...
Rattling Fan Noise from Kitchen Aid Oven - Dead dishwasher after NEW parts!!!!!
Bump. Need to get this figured out.
Heating Element Not Working? - Dead dishwasher after NEW parts!!!!!
I used my multimeter to test continuity on the heating element and the high limit thermostat. I unplugged the wired on the heating element and tested between the terminals. I could not get any...
Heating Element Not Working? - Heating Element Not Working?
The other night I notice my water heater had tripped, so the incoming water to the dishwasher was cold. However, I was under the impression that the heating element should attempt to heat the water...
Rattling Fan Noise from Kitchen Aid Oven - Rattling Fan Noise from Kitchen Aid Oven
When the oven is turned on, there is a rattling noise that seems to be associated with a fan somewhere in the unit. It happens whether the convection oven is turned on or not. Is this simply...
Torsion Spring on Door Broke AGAIN!!! - Torsion Spring on Door Broke AGAIN!!!
Well, I had to go through the procedure of getting the right springs for this microwave oven. I have a black one, and when I ordered the springs back in 2013, the ones on the site were wrong and...
Ice Maker Leaking a lot - Torsion Spring on Door Broke AGAIN!!!
Well, I did take off the water valve, and I checked it with my Ohmmeter, I think it was ab 196 ohms, so I deemed it OK. I DID see a chunk of ice in the maker under the fill tube, so that would...
Forum Info Contact Info
Join Date: 08-26-2011
Posts
Total Posts: 36 (0.02 posts per day)
Last Post:
Ice Maker Leaking a lot
04-19-2016 02:57 PM
Find all posts by agdodge4x4
Find all threads started by agdodge4x4
Referrals: 0
agdodge4x4 has no contact information.
Additional Information Group Memberships
N/A
agdodge4x4 is not a member of any public groups


All times are GMT -7. The time now is 08:54 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17