How to chamber bulb in GE microwave
I normally just cut a piece of like 16 guage wire, twist about 4 strands together and solder it in. No need to use the insulation of the wire.
|
How to chamber bulb in GE microwave
If your gonna resolder the burnt trace, you will see where the trace meets some pins that are already soldered, just attach the wire to those pins.
|
|
|
microtemp switch
No, it won't light. The tester needs a hot and nuetral/ground connection for it to light.
|
|
|
Temperature Control Problems
To check if the damper door is broken, remove the light cover at the top of the refer, remove the rear light bulb. Shine a flashlight down the hole and see if the damper door is laying in there, push...
|
Microwave Vent Light and Fan
If you or someone you know can solder, you can save money by soldering in a piece of wire where the trace is burnt on the back of the board.
|
All times are GMT -7. The time now is 07:31 PM.
The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc.
