Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » 80sGuy

View Profile: 80sGuy
80sGuy is on a distinguished road
80sGuy 80sGuy is offline
Junior Member
 
Last Activity: 09-16-2009 11:45 PM 

Maytag Expands Recall of Refrigerators Due to Fire Hazard
Well, most of us here have already remedied the problems associated with the relay. I replaced the newly redesigned 2-pc relay kit (over the old one-piece) right away last August when my fridge was...
Maytag refrigerator,
Does it make any clicking noise from the compressor area?
Runs continuously/freezer not cold enough
If it's defrosting fine, makes ice and the fresh food section is cold as normal then I would assume it's your 'defrost thermostat'.
Fridge cycle/interval after defrost. - Fridge cycle/interval after defrost.
Is it normal for a fridge to run longer after its been defrosted? Before this, my 18.6 cu. ft. Maytag top-mount usually cycles on/off for approximately 14 minutes (for cooling) and about 15-16...
Fridge doors won't swing itself back to close anymore... - Fridge cycle/interval after defrost.
Yeah, I was gonna wait till the food item decreases then take the doors off and see what the heck is going on in there. So does this mean the doors for this particular model is non-user serviceable?
Fridge doors won't swing itself back to close anymore... - with pics this time...
Gene,
I put a mirror to the floor and took some photos of the reflections. The pin seems to look fine, but if you look carefully, the part seems to be hollow and can be seen through all the way to...
Fridge doors won't swing itself back to close anymore... - with pics this time...
I put a mirror and reflect the inside bottom of the pin and got a glimpse of it and it looked hollow (see through) whereas the ends are sealed compared to the listed part.
Forum Info Contact Info
Join Date: 08-28-2008
Posts
Total Posts: 22 (0.01 posts per day)
Last Post:
Fridge doors won't swing itself back to close anymore...
09-23-2008 01:16 PM
Find all posts by 80sGuy
Find all threads started by 80sGuy
Referrals: 0
80sGuy has no contact information.
Additional Information Group Memberships
N/A
80sGuy is not a member of any public groups


All times are GMT -7. The time now is 09:36 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17