General Talk

chiko · #1 (**permalink**) 01-09-2008, 07:50 AM

I was told the timer to be replace and I did it. However, the washing machine cycle will not advance with the new timer and same with the old timer. Is there something else that may be malfuctioning? Or it too expensive to repair and it is time to get a new one.

Thanks

Gene · #2 (**permalink**) 01-09-2008, 05:38 PM

Hi Chiko,

Most likely the problem with your washer is a bad main control board which should control the timer advancing.

- The part number for the main control board is AP251699

- Here are the break down diagrams for the Maytag Neptune washer Model MAH4000AWQ

Good luck.
Gene.

dfriddle · #3 (**permalink**) 06-23-2008, 06:39 PM

There are 2 timers for the model Maytag that I have (LAT9406AAE), and they look exactly the same. Apparently they are wired different. You probably have the wrong timer.

madmike661 · #4 (**permalink**) Today, 06:24 AM

I was told the control board needed to be replaced and I did that. Now the washing machine cycle is not advancing with the new control board. Can you tell me what is the next step?

thanks mike

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Washing Machine	Bob Mutersbaugh	Washer Repair	4	03-04-2008 11:45 AM
maytag neptune washing machine	kilman	Dishwasher Repair	1	11-02-2007 01:58 PM
Washing machine	Novice	Washer Repair	2	10-08-2007 11:22 AM
washing machine takes hours to finish washing a load	kelly Monday	Washer Repair	2	09-26-2007 02:42 AM
GE washing machine	paul	Washer Repair	2	07-19-2007 07:13 PM

Maytag washing machine mah4000awq 5 to 10 years old.

General Talk

I was told the timer to be replace and I did it. However, the washing machine cycle will not advance