|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Kenmore 500 disposer runs but blades not moving |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
02-27-2010, 08:42 AM
|
|||
|
|||
Kenmore 500 disposer runs but blades not moving
Model Number: 175.66554 Brand: Kenmore Age: 5 - 10 years
Hello, I have a Kenmore 500 Disposer 175.66554. I was running it the other day and the motor runs but the blades in the sink don't turn. Is there a jam nut I can tighten or is it just time to replace the Disposer? I have never done this type of job and didn't want to jump in blind. If I have to replace it will I have to rework the drain pipes or are most disposers the same? Will be be an easy replacement? I am good with tools and know basic electrical as the motor is hard wired. My only concern is if I will have to redo the drain system. Any help will be greatly appreciated... Thanks Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Disposer turns on but blades don't turn | Murdock | Garbage Disposer Repair | 2 | 02-27-2010 08:40 AM |
| Kenmore Garbage Disposer replace Vanes | bvlusa | Garbage Disposer Repair | 0 | 12-28-2009 02:38 PM |
| Kenmore Agitator Moving Correctly? | bacmb | Washer Repair | 1 | 10-07-2009 06:04 PM |
| kenmore washer top agitator not moving | paulisofi | Washer Repair | 3 | 06-23-2009 01:48 PM |
| Fills+drains pump runs but wash arms not moving | aace73 | Dishwasher Repair | 3 | 02-07-2008 07:15 PM |
Linear Mode
