|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Flange snap ring not holding, specialty flange |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
11-27-2008, 11:57 AM
|
|||
|
|||
Flange snap ring not holding, specialty flange
Brand: Kenmore Age: Less than 1 year
We ordered a new specialty disposal flange to match our new sink. The groove may not be deep enough as the ring keeps popping out when tightening the mounting screws. I can't seem to get the flange tight enough to keep from leaking under the rim of flange. Any tricks for getting the ring to work or should I just use silicone instead of putty between flange and sink?
    
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| In sink-erator flange removal | RonOh | Garbage Disposer Repair | 8 | 09-12-2008 07:55 AM |
| Icemaker Auger nut/snap ring replacement | Bret Dinkins | Refrigerator & Freezer Repair | 0 | 08-29-2008 08:21 AM |
| Screw holding wash impellar won't loosen | rbayer | Dishwasher Repair | 3 | 04-18-2008 04:46 AM |
| Replace disposal flange | redfox | Garbage Disposer Repair | 2 | 03-30-2008 02:22 PM |
| Frigidaire Handle Flange Broken | AtlDick | Microwave Repair | 1 | 02-11-2008 05:55 PM |
Linear Mode
