|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Flange vs. Gasket: Help??? |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
07-08-2010, 09:01 AM
|
|||
|
|||
Flange vs. Gasket: Help???
Model Number: KCDS250X3 Brand: Kitchen Aid Age: 1 - 5 years
I'm still not 100% sure which part of my problem is labelled what, so perhaps someone here could help?
The rubber "splash guard" that sits between the hole in the sink and the grinder of my garbage disposal unit is ripped up and horrifying, not to mention completely ineffective. On Section replacement parts for WHIRLPOOL KCDS250X3 | AppliancePartsPros.com, where the parts for my disposal unit are listed, we've got what looks ALOT like what I'm looking for; it's #14 and is listed as a Gasket. First, is this the "splash guard" I need? Second, what else should I replace re: this old splash guard? Would I need to replace the parts around it, i.e. the screw, ring-snap, flange-mounting, etc.? Thank you in advance for any help you can give me; e-mailing directly at jamador@aquitall.com would be grand, but if it's against policy I'll still be checking here every few hours. Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tub flange sealant | mcrum | Washer Repair | 1 | 04-04-2010 04:40 PM |
| Washer Flange Torn Away | supernova | Washer Repair | 0 | 03-04-2010 08:11 AM |
| Removing the spin shaft flange | J1m | Dishwasher Repair | 4 | 05-04-2009 10:06 PM |
| Flange snap ring not holding, specialty flange | wranglerbrat | Garbage Disposer Repair | 0 | 11-27-2008 10:57 AM |
| Replace disposal flange | redfox | Garbage Disposer Repair | 2 | 03-30-2008 01:22 PM |
Linear Mode
