|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » signature dryer |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
08-29-2007, 07:48 PM
|
|||
|
|||
signature dryer
Model Number: mde336mbw0 Brand: -brand- Age: More than 10 years
trying to get to the tumber to replace the belt. Don't know how to get to it. thanks
     
|
|
08-30-2007, 12:23 AM
|
|||
|
|||
|
First, make sure power has been disconnected to the dryer. Insert a putty knife (or something similar) between the top and front panels, about 2 inches from the end on each side. This will release the clips that hold the top panel to the front panel. Raise the top panel. You can then remove the front panel (should be a couple of screws, one on each side).
Hope this helps.
|
|
09-03-2007, 01:31 PM
|
|||
|
|||
|
By doing what I've described in the previous post you will get to the drum.
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
