Rank: Member
Groups: Registered
Joined: 1/18/2010(UTC) Posts: 1
|
I'm having problems with my dryer not heating continuous and finally on last test, not heating at all. I was able to hold down the home and adjacent button to get me into test modes. I was able to test blower as it ramped up over 2000rpm. My question is the t(in) and T(out) readings when blower was not on, I had a reading of a continous 156 or 159 on the T(in) actual reading. My T(out) had a 78 degree. I left the blower running for a while on test and only seen a couple degree change on T(out). The t(in) stayed the same. I did ramp up the Drum motor, also it seemed to be ok. Is the flame supposed to go on then after a period of time shut off momentarily, then return to the on position. This was happening quite often when heat was temporarily working. I also noticed settings in the different displays. Do you know the default settings to these parameters. Do you think that my thermisters are faulty and shutting down the flame. The temperature nver acheived the 400+ degee. Can you give me some input on this problem?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close