|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » How do I adjust the Moisture Sensing circuit |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: 110.72062100 Brand: Kenmore Age: 1 - 5 years
I have a Kenmore Elite gas dryer. It has worked well over the past 3 years, but the Ultra Moisture Sensing Auto Dry Level control has been leaving the clothing more and more moist at a given moisture setting as the years go by. The vent is clear, the area under the filter is clear and I get very good air flow out the vent. I'm guessing that there is an adjustable potentiometer (variable resister) on the circuit board that is used to fine tune the moisture sensing circuit. Does anyone know if one exists or where it is located?
Ads By Google Related Models |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dryer sensing | Mooresville78 | Dryer Repair | 6 | 02-26-2010 03:27 PM |
| "auto moisture sensing" problems | gonecampin | Dryer Repair | 3 | 11-18-2009 05:00 AM |
| Dryer only sensing and will not run. Sensing just flashes. | carolray2 | Dryer Repair | 1 | 05-05-2009 02:30 PM |
| Elec dryer, low heat, moisture monitor reads low moisture | ratflinger | Dryer Repair | 3 | 11-17-2008 08:52 AM |
| Auto Moisture Sensing Plus not working | mschmero | Dryer Repair | 2 | 01-06-2008 11:55 AM |