|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Trying to figure out the age of my dryer |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: 86692820 Brand: Kenmore Age: More than 10 years
I'd like to try to figure out the age of my dryer. It is a Lady Kenmore Ultra Fabric Care.
Model # 86692820 Serial # m83508227 We bought it used and have had it for the last 9 years, so I know it is at least 10 years old. The signal that tells you it is done drying doesn't work; timed dry only works sometimes. Sometimes it works, other times, you'll go in to check on it and the timer still reads 70 minutes, after it's been in there for about an hour. The lint trap door (located on the top of the dryer) broke off during a move. Now I have to use a butter knife to get the lint trap out. Also, the darn thing won't put out any hot air, only cold air, so we are planning on buying another dryer. I am just curious as to how long this dryer lasted. Related Models |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
|
|||
|
It is most likely correct. We bought the dryer for around $145 back in 2001. I can't believe that dryer lasted that long! WoW! I hope the new one I am getting lasts that long! Thanks so much for answering my question; I've always wondered how old it was, but didn't know that there were forums, like these, on the internet.
|
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can't figure out my dryer problem | sensa_10d | Dryer Repair | 1 | 05-06-2009 09:58 AM |
| Can't figure out problem with washer | mr1drful | Washer Repair | 1 | 04-21-2009 10:32 AM |
| Trying to figure out if I should repair or replace | ghen | Refrigerator & Freezer Repair | 11 | 03-21-2009 07:30 PM |
| cant figure how to get belt on tight | kc.58 | Dryer Repair | 1 | 10-31-2007 04:46 AM |
| help i cant figure this one out | steve_v | Dryer Repair | 3 | 08-30-2007 03:00 PM |