Rank: Member
Groups: Registered
Joined: 8/26/2015(UTC)
Posts: 1
|
I needed to replace the heating element on my dryer so I watched several repair videos and ordered the part. The problem is, when I took the back off my dryer, the heating element housing does not look like the ones in any of the videos I watched. According to the videos, there should be a screw on either side of the housing to remove and then it slides off. There are no screws at all. My housing is all one piece. Any ideas on how to get it off?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
Take a look at the last post in the Q&A section. Part number: AP3109438
Click on the picture to get to the page with the Q&A's |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
