Dryer Repair

Penthor · #1 (**permalink**) 02-16-2008, 07:34 PM

The tub spins and everything else seems to work fine. The appliance seems to be in good condition and is installed indoors. I found a similar post here If those same instructions apply to my particular model I'll proceed with the continuity testing in the morning. Thanks. And great forums!

Penthor

Penthor · #2 (**permalink**) 02-17-2008, 07:32 AM

Looking at the machine I can't tell the best route of entry. Is it best (possible?) to go in through the top, front, or back? Thanks.

Penthor · #3 (**permalink**) 02-17-2008, 08:29 AM

FYI

The back is the best route to take. My thermal fuse was blown. It's eerie how just talking to myself on this forum has helped me solve the problem.

Penthor · #4 (**permalink**) 02-17-2008, 08:56 AM

Out of curiosity is there a way to test the cycling thermostat with an Ohm meter? It has 4 leads. The circuit between the 2 outside leads is closed; between the 2 inside it is open.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dryer not heating	rcabalo	Dryer Repair	2	11-26-2009 09:52 AM
dryer not heating	doghouse3	Dryer Repair	1	09-23-2009 06:11 AM
dryer not heating	iyacko	Dryer Repair	2	08-26-2009 12:50 PM
dryer not heating	ecubulldog	Dryer Repair	1	07-05-2009 07:40 AM
Dryer not Heating	stompy27	Dryer Repair	0	11-05-2008 06:06 AM

Gas dryer not heating

Dryer Repair

The tub spins and everything else seems to work fine. The appliance seems to be in good condition and is