GE Profile elec dryer DPSE810EG0WT
I purchased and control board (AP4980747 - WE04M10004 BOARD ASM. MOUNTED ) from AppliancePartsPros and replaced the suspect board. This seems to have fixed the problem (dryer would not start - could hear relay clicking but the motor did not start. I had checked all the Thermostats and switches previously) the motor started and a cycle commenced. However, when I push the stop button the display starts sequencing through these letters (P, PA, AU, US, SE, E) and will not stop until either the start button is held for over 3 secs or the plug is pulled. When power is reapplied the sequence starts again - however a cycle can be set and started - the display then shows the correct info (time remaining and sensing). When the cycle finishes or stop button pressed the display starts cycling the letters again. Seems to me that I should be able to reset this, but have no idea how to do it.
Ads By Google