|Register | FAQ's | New Posts | Today's Posts | Extras|
Continues to "sense", cycle never starts.
Model Number: GEW9868KQ4 Brand: Whirlpool Age: 1 - 5 years
My Whirlpool Senseon dryer is not starting its cycle. When I attempt to start any of the various cycles, the "Sensing" LED lights up and continues to stay lit, all the while the dryer never starts its cycle.
When I do the Moister Sensor Diagnostic test (via technical sheet), when I open the door the error code 7E shows up on the display. It is my understanding that this means there is a short circuit in the moisture sensing system.
I have tried, with no luck:
- Replacing electronic control
- Replacing LED Console Panel
- Replacing thermal fuse
- Replacing thermistor
Note - I have done the diagnostic tests and measurements. I replaced the above via recommendation from a parts store (fyi - I was fully refunded for returning all of them). I did not necessarily agree with trying to replace of those parts, but did it through their recommendation.
Next steps: Should I maybe try replacing the moisture sensor harness?
Ads By Google
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|GE gsl25jfphbs "trips" out; starts working when rep lugged||bchain||Refrigerator & Freezer Repair||8||03-05-2012 05:21 PM|
|Igniter continues to spark w/ knob in "Off"||Steve Y||Oven Repair (including Ranges and Cooktops)||0||11-24-2011 06:41 AM|
|Dryer starts, ignites, shuts off. Works fine in the "no heat- air fluff" mode||doyfam5||Dryer Repair||0||07-31-2011 07:39 AM|
|Timer moves during "timed dry" but not during auto sense||zachunderwood||Dryer Repair||0||01-27-2010 12:02 PM|
|Starts cycle, gets "stuck" with h2o in bottom, timer is still heard-lights on too.||julialovesjohn||Dishwasher Repair||1||10-03-2007 07:16 PM|