Dryer Repair

Turbo Mouse · #1 (**permalink**) 10-05-2009, 11:45 AM

Yesterday I dried a load and then the second load had no heat. We checked and the flame was not lighting although there was an orange glow. Today I get the orange glow and the dryer lit but I thhink I have a problem. What part(s) should I look to replace so that the dryer will work and stay lit?

SublimeMasterJW · #2 (**permalink**) 10-05-2009, 02:12 PM

This old dryer has a set of 3 operator coils.
NOTE:These coils must be replaced EXACTLY as positioned on the old gas valve.
I suspect they are getting a little age on them. If the ignitor is working then the control is functioning therefore in my opinion the coils are probably getting hot and fading. I looked up the coils:
Click HERE to view the kit. You will note that each coil has different colored wires, pay attention to that! Wire it up wrong and it will not work. Stack the coils wrong and it will not work.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Heating coil or Heating element assembly	jayclagg	Dryer Repair	1	02-11-2010 07:26 AM
Heating element stopped heating JSP38G0T1BB	Gravity Railroad	Oven Repair (including Ranges and Cooktops)	1	06-23-2009 02:10 PM
Bottom heating element in oven not heating	Bill Pitts	Oven Repair (including Ranges and Cooktops)	1	03-07-2009 06:02 PM
Heating element not heating	JBM	Dishwasher Repair	5	11-27-2008 11:37 PM
dryrer stopped mid stream	flippinstick	Dryer Repair	2	11-02-2007 10:44 AM

Gas Dryrer not heating

Dryer Repair

Yesterday I dried a load and then the second load had no heat. We checked and the flame was not