[Reeku]

I have a Whirlpool Senseon (Model #GEW9868KQ3) Electric Dryer, the display does not show anything, and a display test will not work either. The dryer is getting power and the breaker is good. The dryer worked perfectly fine up-til now, it just will not respond to any key presses. The dryer door switch doesn't show damage, and the lint trap has been cleaned as well as the exhaust.

I used a Voltage Test pen to see if power was being supplied to the power housing and from the outlet, and it had indicated there was a voltage in both areas.

I know there are thermal fuses, as well as many other fuses in this particular dryer, but I am not sure how to get to them. I am also hoping that its not a bad control panel, I am trying to save as much money as possible... thus me being here.

[Gene]

Hello,

Unplug the dryer. Remove the terminal block cover and inspect the power cord connections to the terminal block.

Plug the dryer and check for 120 VAC between the Black wire & the White wire and the Red wire & the White wire. Check for 240 VAC between the Black wire & the Red wire.

If the readings are correct, check for 120 VAC between the wires connected to the terminals P1-2 & P1-5 at the control board.

If the reading is correct, replace the control board.

- The control board Part number: 8566150

Here are the breakdown diagrams and Parts for Whirlpool GEW9868KQ3 Dryer - AppliancePartsPros.com

Gene.