Rank: Member
Groups: Registered
Joined: 9/21/2009(UTC)
Posts: 1
|
I have a kenmore dryer that will not heat. I opened the front panel and watch the dryer start. the flame stayed on for about 45 seconds. after that it would go out than the ignitor would glow and stop.
I replaced the coils on it and the new coils would not even let it light. Thinking I got a bad set of coils I went to exchange them and these coils start to make a buzzing sound when the ignitor comes on.
I am now at a lost and would greatly appreciate some help.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/21/2009(UTC)
Posts: 1
|
I am having a similar problem with my Kenmore Elite H3 gas dryer. The dryer starts, element glows, flame ignites, but goes out after 30-40 seconds. If you allow the dryer to run, it will cycle on but go out after 10-15 seconds. After much researching I believed it was the coils as well. After talking to a technician this AM it could be the thermostat. I ordered I set of coils and a thermostat and will see what works when they arrive tomorrow.
Good luck. I will repost and let you know what I find out.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
