Dryer Repair

yzhong · #1 (**permalink**) 08-10-2009, 01:13 PM

My dry ran but no heat. After replacing the fuse, thermostat, and ignitor, when I turned on the dryer by closing the door and pushing the Start button, the new igniter was NOT burnt to red, i.e., I did NOT get a glow in the ignitor. The dryer still ran but no heat. Is there a problem of electric circuit? If so, what to do? Thank you. Adam

magician59 · #2 (**permalink**) 08-10-2009, 04:03 PM

Open it up and check to make sure you properly and securely reconnected the wire connectors. If everything is OK, take the wires off the flame sensor and tape them together very securely, making certain they can't come into any metal contact. Start the dryer to see if you now get a glow and a flame. If so, replace the sensor.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
No Voltage, No Gas, No igniter glow	jmrec100	Oven Repair (including Ranges and Cooktops)	33	04-11-2011 02:55 PM
Replaced Glow Igniter, Sensor and coils yet no heat in dryer	Camann	Dryer Repair	0	12-17-2009 08:19 AM
new oven igniter will not glow	bubby	Oven Repair (including Ranges and Cooktops)	11	09-28-2009 02:24 PM
Whirlpool gas dryer, with fuse, thermostat, and igniter, still run but no heat	yzhong	Dryer Repair	3	08-10-2009 07:32 PM
glow igniter	mackdj10@gmail.com	Oven Repair (including Ranges and Cooktops)	1	06-01-2009 02:51 PM

Gas dryer with new fuse, thermostat & igniter. Igniter did NOT glow & no heat

Dryer Repair

My dry ran but no heat. After replacing the fuse, thermostat, and ignitor, when I turned on the dryer by