Dryer Repair

bluesdues6 · #1 (**permalink**) 07-09-2009, 07:22 PM

My dryer will start the gas and run for about 5-7 minutes. Then the gas shuts off. The igniter will glow for about 15-30 seconds every couple of minutes but there is no flame. It's like there is no gas to ignite. Do I need a new gas valve or is there another possible cause? I have already replaced the vent, the operating thermostat and both coils and that doesn't seem to have helped.

Gene · #2 (**permalink**) 07-10-2009, 02:18 PM

Most likely the problem is a bad gas valve coils (#13 & #14 on the diagram).

- The coil kit Part number: AP3094251

Here are the breakdown diagrams and Replacement parts for WHIRLPOOL LGQ9858LW0 | AppliancePartsPros.com

Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Oven Flame Is Yellow And High. Flame Doesn't Regulate	COOLJADE	Oven Repair (including Ranges and Cooktops)	0	02-25-2010 03:28 PM
No flame	akoballa	Oven Repair (including Ranges and Cooktops)	3	07-12-2009 09:56 PM
flame on but then goes out	zorst	Dryer Repair	1	01-19-2009 04:50 AM
No Flame	FDAR	Dryer Repair	5	12-23-2008 06:39 AM
no flame	jeffmorelock	Dryer Repair	1	10-01-2008 06:05 PM

My Old Flame

Dryer Repair

My dryer will start the gas and run for about 5-7 minutes. Then the gas shuts off. The igniter will