|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Temp. switch |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
12-07-2007, 05:20 PM
|
|||
|
|||
Temp. switch
Model Number: KEYS750JQ1 Brand: Kitchen Aid Age: 1 - 5 years
Dryer is heating when set on med. heat but will not heat on high heat setting.
What part do I need to replace? Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
12-07-2007, 06:53 PM
|
||||
|
||||
|
Well you are looking at the temp selector switch, or the operating thermostat. If you get into the back of the control panel, you can use an ohm meter to verify the switch is reading continuity in each of the selection positions. The thermostat is behind the rear panel and just above the vent outlet. It should ready continuity between both red wires and about 6k ohms between the two violet wires. If any contacts on the switch ready open, replace the switch. If the thermostat doesn't ready as I stated above, replace it. Easy fixes.
TechnicianBrian
|
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| whiplpool temp/fabric switch wiring diagram | atcher service | Dryer Repair | 0 | 12-14-2009 06:46 AM |
| Kenmore Fabric Temp Switch doesnt seem to work | dtailer | Dryer Repair | 4 | 12-05-2009 03:19 PM |
| Oven Temp switch works part time | chiefy3 | Oven Repair (including Ranges and Cooktops) | 1 | 01-02-2009 05:57 AM |
| How to access the panel to change temp switch | kwmir | Washer Repair | 0 | 06-25-2008 09:20 AM |
| Freezer Temp Irratic. Refer temp OK | tomd | Refrigerator & Freezer Repair | 2 | 12-31-2007 03:13 PM |
Linear Mode
