|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » dryer will not start |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: 11066912692 Brand: Kenmore Age: 5 - 10 years
dryer will not start
Ads By Google Related Models |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
|
||||
|
Verify voltage to the machine. Make sure you hear a click when the door switch is actuated. Then unplug the unit and remove the lower access panel. On the exhaust duct, there is a white thermal fuse (AP3133489) that may have opened the motor circuit. Temporarily remove the two wires and slide the connectors together. Make sure the connectors are not touching any metal, then plug the dryer back in and test it. If the fuse was bad, it should start. If it doesn't, unplug the dryer, put the wires back on the fuse and then it's time to get out a multimeter and start checking the door switch and push-to-start switch.
|
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HOT POINT DRYER has power but start button doesn't start the dryer. | HOT POINT | Dryer Repair | 2 | 08-01-2011 06:47 PM |
| whirlpol dryer won't start-just hums when I push the start button | bdubois | Dryer Repair | 27 | 02-18-2010 07:36 PM |
| dryer start but stops when I release start button | vchss360 | Dryer Repair | 7 | 10-20-2009 03:46 AM |
| Kenmore Dryer won't start unless PTS (push to start) button depressed and held | trp | Dryer Repair | 1 | 06-07-2009 06:13 AM |
| dryer start button noise - dryer won't run | brhodes58 | Dryer Repair | 6 | 03-14-2009 02:11 PM |