Dryer Repair

MonsterBash · #1 (**permalink**) 02-02-2009, 05:10 AM

I have a Frigidaire Gas dryer that after doing some research here..I do believe the Gas Valve Coil(s) are shot.

I can see the burner light..then it will just shut off. Sometimes it dries good..most time the burner just doesn’t light.
My question is how do I get to the coils? Of course I left the model of the dryer home but I can say it a cheapo $400 gas dryer bough about 5 years ago new. There’s what looks like a vent plate on the lower left (if you’re looking at it from the back) I removed that and the motor is right there. I can see the gas valve and burner assembly all the way to the right but can’t get to it from there.
I removed the top but there’s no way I can get to it there. There’s no access panel anywhere near the burner. DO I have to go in through the bottom?

Thanks!

Gene · #2 (**permalink**) 02-02-2009, 05:05 PM

Unfortunately we can not proceed with any advises without the complete model number.

Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
gas valve coils	joe209	Dryer Repair	5	10-10-2009 02:39 PM
Access To The Heat Duct Assembly-coils	shirleyc	Dryer Repair	4	05-15-2009 06:45 PM
Gain access to ice dispenser trap door	raineri4	Refrigerator & Freezer Repair	1	05-14-2009 10:54 AM
Wanted to know to gain access to replace part??	Tryingtofix	Dryer Repair	1	03-13-2009 08:58 PM
How to remove panels to access coils	Davidrod777	Dryer Repair	3	08-22-2008 10:25 AM

How to gain access to the Gas Valve Coils

Dryer Repair

I have a Frigidaire Gas dryer that after doing some research here..I do believe the Gas Valve Coil(s) are shot.