|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Which wire to which terminal on the flame sensor? |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
01-13-2009, 04:22 PM
|
|||
|
|||
Which wire to which terminal on the flame sensor?
Model Number: LGQ8858HQ0 Brand: Whirlpool Age: 5 - 10 years
Oops - I removed the flame sensor from the dryer but forgot to track which terminal gets the blue wire and which gets the white one. Could someone tell me if I promise never to make such a stupid mistake again?
 The Part is #AP2910747, and here's a link: Model LGQ8858HQ0 The two terminals are distinguishable (to my amateur eyes), by the length of the plate that runs along the unit - one has a long plate, with a drop of "wax" on it, and one terminal has only a short plate. Which one gets which wire? Thanks. Related Models     
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
01-14-2009, 12:58 AM
|
|||
|
|||
|
all fixed
Well I put it back together with the blue wire on the top terminal and the white one on the bottom, and it worked just fine. Thanks to all the experts on this forum.
|
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| flame sensor | sarrah76 | Dryer Repair | 1 | 01-10-2009 06:38 AM |
| flame sensor | sarrah76 | Dryer Repair | 1 | 01-10-2009 06:37 AM |
| Burnt red wire at terminal | mpd | Dryer Repair | 1 | 05-21-2008 03:11 PM |
| Terminal Block / Wire Harness installation | mmol_75 | Dryer Repair | 1 | 04-01-2008 04:30 PM |
| Moisture Sensor wire | dwiley824 | Dryer Repair | 1 | 09-09-2007 09:21 PM |
Linear Mode
