|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » GAS Dryer Problem |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
10-22-2007, 06:38 PM
|
|||
|
|||
GAS Dryer Problem
Model Number: MDG9316AWW Brand: Maytag Age: 5 - 10 years
WE have checked the exhaust duct and it is clear. The dryer heats for about 10 to 15 minutes and then stops heating. The gas flame ignits but goes out in about 10 to 15 minutes into the cycle. It still tumbles, however.
    
|
|
10-22-2007, 06:56 PM
|
||||
|
||||
|
Hi MISS
If the flame ignites only a few times at the beginning and then the igniter glows but the gas does not coming out, then the problem is a bad coils on the gas valve. Replace them and the problem solved. The set of the coils - The part number for the set of the gas valve coils AP3094251 - Here are the break down diagrams for the Maytag dryer Model MDG9316AWW Good luck. Gene.
__________________
Professional appliance repair in Los Angeles, California.
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dryer Timer Wire problem | deleriousone | Dryer Repair | 17 | 08-06-2008 02:21 PM |
| Bosch Axxis dryer problem | Chipper | Dryer Repair | 2 | 04-01-2008 06:43 PM |
| Dryer heat problem | Dale | Dryer Repair | 1 | 10-02-2007 04:54 AM |
| gas dryer heating problem | sakks | Dryer Repair | 1 | 09-14-2007 06:45 AM |
| Dryer Problem | TerryW | Dryer Repair | 2 | 09-11-2007 09:45 PM |
Linear Mode
