Dryer Repair

starr · #1 (**permalink**) 10-19-2007, 06:31 AM

I Test For Voltage At The Motor. I Have Voltage There.could There Be Anything Else Beside The Motor. The Belt Was Broken When Itookthe Dryer Part.

Pegi · #2 (**permalink**) 10-19-2007, 02:44 PM

Whirlpool DOTT dryer, you have 120 volts at the motor??? and it is dead? if this is so, about the only thing could be a bad motor if voltage at the motor itself , altho I have never seen one go bad like this, they usually hum or something....check that broken belt switch, kills power to the motor when the belt breaks, door switch, check it too....

richappy · #3 (**permalink**) 10-20-2007, 03:44 AM

Pins 4& 5 should have 115 volts there and motor should run. If so, you have an open motor, sort of rare.

starr · #4 (**permalink**) 10-20-2007, 05:52 PM

there was 120 v at the blue @white wires . tell me more about the broken belt switch where is it located? must the belt be on to work?can i by pass the switch to see if the motor turn on? starr thank for help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
dryer motor wire diagram	loweluckie	Dryer Repair	8	02-10-2008 11:43 PM
Motor not working properly	W. Henderson	Washer Repair	0	08-14-2007 07:06 PM
Dryer motor R&R	Pete	Dryer Repair	0	08-14-2007 01:38 PM
Roper dryer - 95 volts on timer motor	jazbird1	Dryer Repair	1	08-10-2007 09:49 PM
Dryer motor is noisey and sometimes humms and doesn't start	Tudeman	Dryer Repair	2	07-20-2007 04:20 PM

Dryer Motor Not Working

Dryer Repair

I Test For Voltage At The Motor. I Have Voltage There.could There Be Anything Else Beside The Motor. The