Dryer Repair

dmcglynn · #1 (**permalink**) 10-16-2007, 12:45 PM

I have a Sears Kenmore dryer Model 110-63952. Drum is making a metal on metal sound. The felt seal on the front of the drum has come off. It is still intact however. After researching some I believe this occurred because I affected the drum support when didn't replace all the screws when I attemped to remove the rear panel. After I replace the screws in the back panel so it properly supports the drum, can I use the old felt seal, or do I need a new one? I was gioven Part# 280114 as the replacement felt seal if I need to order. Do you have instructions for this procedure? Thanks

Bigboss88 · #2 (**permalink**) 12-07-2007, 08:31 AM

Its sad that after almost two months, you have not received a response. This speaks volumes of this forum site.

Bigboss88 · #3 (**permalink**) 12-07-2007, 08:33 AM

I recommend that you do replace the seal. A poor seal adds an extra load on the motor and will cause premature motor failure.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
dryer drum banging noise	a2home	Dryer Repair	1	10-12-2007 02:14 AM
Noise and Drum rocking	momdannie2356	Dryer Repair	1	10-04-2007 03:04 AM
Gas cooking range making noise	bostonian	Oven Repair (including Ranges and Cooktops)	0	10-03-2007 08:07 AM
Making Too Much Ice - Now Making No Ice	aolson51	Refrigerator & Freezer Repair	2	09-19-2007 01:59 PM
Gibson Upright Freezer making loud buzzing noise.....	kakizie	Refrigerator & Freezer Repair	0	08-02-2007 03:42 PM

Drum making noise

Dryer Repair

I have a Sears Kenmore dryer Model 110-63952. Drum is making a metal on metal sound. The felt seal