Dryer Repair

welsco · #1 (**permalink**) 11-18-2008, 08:20 AM

My Dryer lights up but goes out after about a minute. I tested the solenoid coils, one was bad, and replaced the bad one, but still am having the same problem. Could there be some other problem. When dryer first comes on flame is strong and bluish in color.

magician59 · #2 (**permalink**) 11-18-2008, 09:52 AM

Normally, we replace the coils as a set. Does this problem occur in any cycle you select?

welsco · #3 (**permalink**) 11-18-2008, 10:49 AM

Hi, I just checked both the timed cycles and the more dry less dry. The flame stayed on for about a minute on more/less and about 15 seconds on the timed. thanks

teagen23 · #4 (**permalink**) 11-18-2008, 04:46 PM

I have the same problem. Admiral dryer. Replaced both coils. Flame comes on then goes out. Then comes on a little later but goes out. Glows for a while.Model # adg7005aww.

icehouse · #5 (**permalink**) 11-18-2008, 07:39 PM

Possibly

Flame sensor - Senses flame for heat allowing gas valve to open.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Replaced Glow Igniter, Sensor and coils yet no heat in dryer	Camann	Dryer Repair	0	12-17-2009 08:19 AM
Gas dryer heat won't stay on, coils replaced	D.ROD	Dryer Repair	1	08-11-2009 10:16 AM
Igniter Glows Replaced Coils Still no Heat	Friar Dryer	Dryer Repair	1	12-05-2008 01:53 PM
Dryer won't heat up/ coils replaced, now what?	lorettab	Dryer Repair	1	10-08-2008 05:49 AM
replaced the coils but still no heat	starrman	Dryer Repair	1	01-04-2008 06:34 PM

replaced the coils, still no heat, now what?

Dryer Repair

My Dryer lights up but goes out after about a minute. I tested the solenoid coils, one was bad, and