Rank: Member
Groups: Registered
Joined: 10/21/2008(UTC)
Posts: 6
|
Fridigaire Gas dryer
I have now replaced the flame sensor, the coils, the hi limit thermostat. I have cleaned and checked that there are no obstructions. I removed the vent so that all air is moving freely through the dryer, but I still don't have any damn heat!
As before, if I remove the front panel the ignitor glows and the flame ignites for about 1 minute, goes out and won't come back on. With the front panel on the ignitor glows but the flame will not ignite at all.
What else could it be?
I started this whole repair process to avoid a service call of a couple hundred bucks but now I'm about $75 into this thing in parts alone.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
I would check the wires or, maybe spend $30-$40 for a service call to let a professional to diagnose the problem. There is something very unusual.
Gene.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
