Dryer Repair

klipshc · #1 (**permalink**) 10-20-2008, 03:35 PM

I have a whirlpool LGN2000LW0 that will ignite and heat up for about 3 minutes then the flame goes out and wont ignite no more. You have to wait about 10 min and then the flame will ignite again. I have looked thru the post and seen others with similiar issues. Most seem to be problems with the coils, Could this be the most likely cause of this.

Thanks

Gene · #2 (**permalink**) 10-20-2008, 07:06 PM

Most likely the problem are a bad coils.

- The part number for the Whirlpool coil kit is AP3094251

This part is on backorder but you can use the same kit from Frigidaire. They are absolutely identical.

- The part number for the Frigidaire coil kit is AP2150379

Here are the break down diagrams for the Whirlpool dryer Model LGN2000LW0

Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
wont stay on	augustincollazo	Heating, Ventilation, and Air Conditioning (HVAC)	0	12-22-2009 10:51 AM
Dryer will not stay ignited	donald E	Dryer Repair	1	07-21-2009 04:51 PM
wont stay on	closer	Dryer Repair	1	07-14-2009 09:29 AM
wont stay on	killingbe3	Heating, Ventilation, and Air Conditioning (HVAC)	0	06-27-2009 01:31 PM
Sears Range - Bake won't stay ignited	f-klein@sbcglobal.net	Oven Repair (including Ranges and Cooktops)	0	10-25-2007 12:54 PM

wont stay ignited

Dryer Repair

I have a whirlpool LGN2000LW0 that will ignite and heat up for about 3 minutes then the flame goes out