[raptor01]

trying to put dryer back together. belt seems a bit loose. how does it need to be routed to be tight?

Also, how do you know when the thermostats are bad?

Thanks

[libertyappl]

You can check the thermostats with an ohm meter, test for continutiy. I'll try to locate a picture of the belt route, might be easier thatn trying to type it all out.

[libertyappl]

Ok, I couldn't find a good picture and I hope you can overlook my crude attemp to tweek a picture. I hope it helps you.
Nat

[raptor01]

I figured it out. The belt goes on top of the idle roller first and then goes around the motor and back up around the tumbler. It's kind of a pain to put on but it is snug afterwards.