Dishwasher Repair

finman · #1 (**permalink**) 02-08-2010, 07:10 AM

On my third control board. Got this one last week. the machine worked fine for a couple of days now it just stopped in the middle of a cycle and the panel lights are all dead.....had to pump the water out with a shop vac. Originally the boards failed by showing a continuous blinking light .....this time nothing. I even put the old board in to see if would still blink...nothing? What should I check now?

denman · #2 (**permalink**) 02-08-2010, 08:52 PM

Cannot find any info using the given model number please check it.

Many DU units have a thermal fuse attached or on the board, perhaps this is blown.

finman · #3 (**permalink**) 02-09-2010, 07:39 AM

yes that was it - thanku. any insight as to what causes that thermal fuse 2 fail?

denman · #4 (**permalink**) 02-09-2010, 08:32 AM

Here is info on a DU1145
Control panel parts replacement parts for WHIRLPOOL DU1145XTPB0 Undercounter Dishwasher | AppliancePartsPros.com

Take a look at Item 6 in Section 2
The harness that comes with the fuse must also be installed.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Control Panel or Electronic Control - which causes blinking panel lights?	MarcLCH	Dishwasher Repair	1	02-25-2010 03:25 AM
Control panel lights up but won't do anything...	jgluck1977	Dryer Repair	0	08-15-2009 11:07 PM
ALL Lights On Panel - HELP Please	jayman7	Oven Repair (including Ranges and Cooktops)	3	05-08-2008 12:23 PM
Re-Set Panel Lights after Install	jayman7	Oven Repair (including Ranges and Cooktops)	0	04-14-2008 10:34 PM

No lights on font panel-nopower??

Dishwasher Repair

On my third control board. Got this one last week. the machine worked fine for a couple of days now