Rank: Member
Groups: Registered
Joined: 12/25/2009(UTC) Posts: 1
|
Replaced detergent / rinse aid dispenser (thank you for the guidance and parts!). DW worked fine for 2 weeks until it stopped mid cycle. No lights on control panel, couldn't reset the unit to get lights on control panel, checked breaker box - there is power to the appliance. Pulled control panel, there is power to the panel. Upon pulling the panel I note about 4 places where some overheating has taken place- slightly melted plastic. Questions: [LIST=1]
What could cause the overheating? Could it be related to replacing the detergent dispenser? What parts might I need? Control panel? Master circuit board? Anyone else experience this challenge?[/LIST]Thanks for the forum and assistance.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close