Dishwasher Repair

bubba12345 · #1 (**permalink**) 12-23-2009, 07:22 AM

I have a bosch dw that just began to show 1 at the end of the cycle. Reading through the forums this is a very common problem with bosch. I removed the control module and I can see the burnt solder connection. Called Bosch and it is covered by warranty but not labor. I wouldn,t mind paying for a repair, but this sounds way too common. I payed $569 for this washer and now probably $100 repair call. The washer has been good to this point but bosch should stand behind their product. The lady I spoke with at Bosch said that this is not a common problem.

Gene · #2 (**permalink**) 12-23-2009, 03:07 PM

This is a common problem. If it will cost you about $100, do it. The part itself cost much more and is available through Bosch only.

Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
oven door is open, but display shows locked	nniakan	Oven Repair (including Ranges and Cooktops)	1	04-21-2010 06:14 AM
GEProfile Arctica Display shows OFF	xmojeezyx	Refrigerator & Freezer Repair	0	11-08-2009 07:01 PM
Display shows 'Door' message	laroco5	Oven Repair (including Ranges and Cooktops)	2	01-09-2009 04:30 AM
Display shows '9' and does not operate	GerryU	Dishwasher Repair	1	01-20-2008 03:44 PM
Left display dead, Righ shows FF5, Oven is OK	Jenny	Oven Repair (including Ranges and Cooktops)	2	09-17-2007 12:03 AM

Display shows 1 and keeps running

Dishwasher Repair

I have a bosch dw that just began to show 1 at the end of the cycle. Reading through the