|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Flashing "Clean" Light |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: 665.16012402 Brand: Kenmore Age: 1 - 5 years
I have a 2005 Kenmore Ultra Wash dishwasher that is not working. The " clean" light on the control panel is flashing. It flashes 7 times then pauses. Could this be a fault code of some sort? I went to the troubleshooting section of my use and care guide, and it said that the machine had malfunctioned and to check the heater circuit. I looked inside the tub and found a melted plastic part on the heater element. I tested the heater and it is ok. 10.9 ohms. I checked the termostat and its ok. It shows an open circuit. There is no high temp termostat or thermal fuse that I can find on this machine. The only other tub sensor I find on this machine is a "Thermister", and my repair manual does not cover this part. I guess my machine is to new to be covered by this repair manual. I need some test data for a "Termister", part #8269208, and any other repair sugestions you may have.
Thanks in advance for any help you can give. Fiver Lee |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "CLEAN" cycle light always flashing | Tadek | Dishwasher Repair | 9 | 07-22-2008 06:01 PM |
| Kenmore doesn't clean-"Clean " Flashning Seven times | demark | Dishwasher Repair | 44 | 03-10-2008 02:17 PM |
| Large burner doesn't work, red "on" light stays lit | Cath | Oven Repair (including Ranges and Cooktops) | 0 | 01-30-2008 08:30 AM |
| dishwasher "lock on" light on | WesleyD | Dishwasher Repair | 0 | 11-04-2007 07:20 AM |
| Starts cycle, gets "stuck" with h2o in bottom, timer is still heard-lights on too. | julialovesjohn | Dishwasher Repair | 1 | 10-03-2007 08:16 PM |